Mast Base
A2060 - Dynamic 60mm block. One of these for each of the main, jib and spinnaker halyard turning points (three total).
A20401 - Dynamic 40mm Block. One for the pole uphaul and one for the outhaul.
A..76-496 - Medium ball bearing cam cleat with mega-pro lead. Three in total installed ontop of the hatch lid. Outhaul, pole up and down each use one. It is recommended the pole-up cam cleat is also installed using an A.293 riser to make it easier to use.
A.293 - 22mm cam cleat lifter. Used to raise the pole up cam cleat.
A4566STRAIGHT - Straight swivel with medium ball bearing cam cleat. Used for the Vang control line. An angled version is also available if you prefer the cam cleat to be angled upwards.
Top tip - If you are finding it difficult to cleat any of the control lines, or find the lines coming from the mast are too high, try fitting an A4675 wire under fairlead to the cam cleat. This will help guide the rope into the cam cleat at the right angle.
|